This command will not change the lines of the whole table, but just move the side line of a cell.
Menu : Express>Table Tools>Drag Segment
Command Entry : BGJT
Operation steps:
1. Start the command.
2. Specify the line of the table for dragging.
3.Specify the place or distance to drag (left is positive), as shown below.
4.Enter to finish the command, the effect as below.
Article ID: 2700
Created: December 2, 2021
Last Updated: December 2, 2021
Author: GstarCAD MY /KW
Online URL: https://www.kb2.gstarcad.com.my/article.php?id=2700