The general steps of creating Dynamic Block
In order to get a high quality Dynamic Block, improve block editing efficiency and avoid repeating modification, we can finish creating Block by the following steps.
- Step 1: Planning
Before creating Dynamic Block, it is essential to plan Dynamic Block, plan the functions, appearance, the method of drawing and required Parameter and Action which are needed to achieve prospective functions.
- Step 2: Draw geometric figure
The included basic pixel during Dynamic drawing, of course, you can draw these pixel in Block Editor (BEDIT).
- Step 3: Add Parameter and Action
This is the most pivotal step during creating Dynamic Block. When editing the Parameter and Action, you not only consider the achievement of Parameter and Action, but also consider the readability of Dynamic Block and the convenience of Modification, let the action point of the Parameter attach on the corresponding pixel as far as possible, and put the Action near to its relevant parameter, if there are more Parameters and Actions, they still need to be renamed for understanding, editing and Modification.
- Step 4: Test Dynamic Block
Save and Exit Block Editor, start the Dynamic Block test to check if it reaches to the prospective effect.
Article ID: 2521
Created: November 9, 2021
Last Updated: November 9, 2021
Author: GstarCAD MY /KW
Online URL: https://www.kb2.gstarcad.com.my/article.php?id=2521