Adds sequential numbering to text objects. The numbering can appear as a prefix, suffix or replacement text. After selecting one or multiple texts, you can set the text sorting method, the starting number and increment of text sorting and generated... Read More
Workflow
This function can add rows to the table. Menu : Express>Table Tools>Add Row Command Entry : BGZH Operation steps: 1. Start the command. 2. Specify the position of the new row, as shown below. 3. The system will add a row below the point you... Read More
You can use this function to select all the objects in specified layer and specified region at one time. Menu : Express>Selection Tools>Get Selection by Layer Command Entry : ETLAYSEL Operation steps: 1.Start the command. 2.Specify an entity... Read More
When there are several texts in the drawing which need to be modified, it would be much more tedious and inefficient to modify them one by one. Change text allows users make bulk modifications to several texts. For example, this function can modify... Read More
If you want to insert information from one document into another document, you can either link or embed OLE objects, which then can be edited from within the destination application, while the information is stored differently. Embed Objects When you... Read More
As the name describes, this function is used to align text. You can select several texts in your drawing to align along X or Y coordinates, or along a line of specific direction. You can access it from: Menu: Text >Text Align Command Entry:... Read More
This function can continuously revise multiple text objects, single line and Mtext are applicable. Menu : Express>Text Tools>Others>Change Character Command Entry : CHGTXT Operation steps: 1.Start the command. 2.Select the text to be... Read More
You can use SKETCHÂ to draw irregular boundaries. Create Sketches You can sketch by using your pointing device like a pen, click to put the "pen" down and start drawing on the screen and click again to lift it up and stop drawing. Sketches can... Read More
Take the step shaft as an example, if we stretch the left part of the step shaft and the keyway still is at the center point of the smaller diameter shaft after stretching, as the following picture shows: Then, we use the "Distance Multiplier"... Read More
Detach leader line from mtext, tolerance, or block reference object. Menu : Express>Dimension>Detach Leaders from Annotation Command Entry : QLDETACHSET Select objects: Select leader line Usage Example: Select a leader line to detach from an... Read More